HTA large Charging Handle

(6 reviews) Write a Review
$19.99

Product Overview

 

  • 3D printed high impact plastic
  • 100% life time warranty
  • Fits all models of HTA Bullpup Stock.
  • Larger so easier to grip.
  • Easy to install, just press on. if you feel the need you can pin it or screw it on or epoxy if needed.

Reviews

(6 reviews) Write a Review

6 Reviews Hide Reviews Show Reviews

  • 5
    Large handle

    Posted by Elbert L Beale on Jan 10th 2021

    Makes charging effortless

  • 5
    Charging handle

    Posted by Rex Horne on Dec 24th 2020

    Give the additional surface area to make racking the round easy. Well made. When you go and install, drop in hot water and soften up. Once on, it’s on!

  • 5
    HTA large charging handle

    Posted by Phil Norman on Dec 23rd 2020

    Nice tight fit. May pin later after a good range session but it is not loose in any way. Really makes for an easier pull.

  • 5
    Works great

    Posted by Rex Horne on Dec 15th 2020

    Fits tight over existing handle. Heated it under water to make it easier to apply.

  • 5
    HTA large charging handle

    Posted by Edward Questell on Oct 30th 2020

    It went on nice and tight diffidently like the larger charging handle I also have your 3 inch barrel shroud and compensator. I will send 6ou a photo of my HTA Bull Pup. Regards Ed

  • 5
    fits like a glove

    Posted by Juan Rivera on Sep 10th 2020

    This fits snug enough to stay on but not to tight that it's hard to remove. The added hole can be used to add a small lanyard in case it does come off. I can now use two fingers on the charging handle compared to before where I can only use one finger. I messed around with it long enough to see if it will fall off. It didn't. Well done