Product Description
****** Exclusively offered by JSARMSCO.com, no one else has these. ******
- Comes in 3 inch or 4 inch length.
- Just remove the two bolts holding the end plate on, insert the extender and replace the bolts.
Some States have length requirements for carbines and rifles, the HTA Bullpup stock with carbine installed is too short. So in these states the law requires you to lengthen the barrel with something pinned in place. If you pin something to the barrel you cannot breakdown your HTA bullpup to clean it or repair it. So I just added to the butt stock to make the overall length of the gun the required length.
Reviews
-
Bullpup Stock extension
This Bullpup extension works great for CA residents. I would suggest adding a thin piece of rubber on the plastic for slippage and shoulder pad.
-
HTA BULLPUP STOCK EXTENDER
Easy install, gives correct length for CA. As its looks like its 3D printed, it would have been nice if you could reinstall the HTA Butt Stock Pad
-
Stock extender
Nice....would be better if it has rubber end pad.
-
Great buy
Great multipurpose accessory
-
stock extender
I Thought it was going to be made of rubber instead of hard plastic!
