Product Description
3D printed from high quality plastic filament.
- 51mm diameter.
- Fits in the scope shade tube end or scope itself
- *** Every Scope is a bit different so fitment might be very tight or a shade loose***
- If snug or shade large, you will need to press fit it. (Carefully apply heat with a lighter to the edge if it needs softening a bit to allow it to be press fitted. 20-30 seconds at most)
- If loose you can shim it with some tape applied to the outside edge to get a snug fit or wrap it in a rubber band.
- unit can be gently sanded to remove material from the edge is too tight and then hit the edge lightly with a lighter to smooth the sanded edge. Be careful to not remove to much material but if you do you can shim it with tape like the last photo. I used masking tape to shim it and it fits snug.
