This unit allows you to remove your pistols rear sight (2 screws). Insert our Hi Point Top Picatinny Rail and use our replacement screws with lock washers for a no drill or mill installation. Recommend using blue lock tight on screws. Clamp on your favorite mini red dot and you are good to go. Want to go back to OEM rear sight, remove two screws and insert your rear sight and install the original screws.
- Fits Hi Point Pistol models with removable rear sight, except the newly released YC9, 10mm, 40 & 45 cal with the Hi Point Logo grips (aka gen2)
- 6061 Aluminum
- 2 1/8 inch long, 5 Slots, .65oz
- This unit has a sight slot in it as a back up rear sight, in case your red dot breaks or battery goes dead. Not sure how accurate it will be, but it should get you close in an emergency.
- Installation screws and lock washers provided. Super tight fit, you may need to sand or file the sides of the unit to get it to fit into the rear sight trough. Or you may need to scrape the sides of the trough to flatten the paint so it fits. Must be super tight to with stand the recoil forces when a red dot is installed and the whipping motion it will create.