Large press on safety lever enlarger

(8 reviews) Write a Review
$9.99

Product Overview

  • 3D printed high impact plastic
  • 100% life time warranty
  • Fits all models of Hi Point poly framed pistols and carbines.
  • Larger so easier to move with the thumb.
  • Easy to install, just press on. if you feel the need you can glue it if needed.
  • May need to use a flat head screw driver to bend the lever up.
  • May need a small hammer to seat the piece, it is a very tight fit.

Reviews

(8 reviews) Write a Review

8 Reviews Hide Reviews Show Reviews

  • 4
    Large press on safety lever enlarger

    Posted by Jeremy May on Jul 20th 2021

    I like this product, makes accessing the safety much more easily. I used a little Loctite and it hasn't budged. The only way it could be improved on would be to manufacture the safety lever in one piece of steel, replacing the factory safety lever. Works good on my C9, plan on purchasing one for my 995 in the near future.

  • 5
    good

    Posted by frederick green on Jul 17th 2021

    great

  • 4
    Safety extender

    Posted by Lm on Jun 2nd 2021

    Overall good. Had little issues to install. Hole little smaller than safety level. But after I istall I can see improvement in operation.

  • 5
    LARGE PRESS ON SAFETY LEVER ENLARGER

    Posted by Charles Girten on May 18th 2021

    Put on my 995 and made the safety much more convenient. Pushed on and stayed tight

  • 5
    LARGE PRESS ON SAFETY LEVER ENLARGER

    Posted by Charles Girten on May 18th 2021

    Put on my C9 and made the safety much more convenient. Pushed on and stayed tight

  • 4
    Much needed enhancement to safety lever

    Posted by Robert Kenyon on Mar 19th 2021

    I love my Hi-Point carbine, but ergonomics is not it's strong suit. The sheet-steel factory safety lever is utilitarian, but it presents a small surface area and can be difficult to operate without shifting your grip. After I installed an ATI stock (the one styled after the Beretta Storm), I found it even harder to engage, because the pistol grip on that stock makes it a little longer reach for my stubby thumb. I previously mounted a thumb stud from a knife making supplier on the lever. It worked fine, but not great. I just replaced it with this press-on safety lever enlarger, and am very happy with it. It appears to be 3D-printed plastic resin so time will tell how durable it is. I had to slightly enlarge the slot with a small file in order to fit the lever. Eventually it pressed on with firm pressure and seated with a couple light taps with a rubber mallet. It's not going to slip off. It gives a much larger surface area and I can quickly and easily engage and disengage the safety without taking my eyes off the target or shifting my grip.

  • 5
    Push on safety

    Posted by Ken on Feb 2nd 2021

    Works like it should. Tight fit and makes it a lot easier to engage the safety.

  • 5
    Press on safety lever enlarger for HP 995

    Posted by Phil Norman on Dec 23rd 2020

    Nice tight fit. Works great and solves the issue of the original small flat lever.